Portable Tire Wash System TW610 8.4 UG

Key Features

  • Rigid Body

  • Easy to operate and maintain
  • Portable configuration
  • Hot Dip Galvanised Structure


TW610 is a Tire Wash system is installed in portable configuration. The system has water collection system to transfer the collected water to a nearby collection tank. Steel Ramps are required for vehicle entry and exit. The structure is made up of Hot Dip galvanised steel. The zinc protection gives a long life. Entry  & Exit ramps are skid proof made with heavy galvanised steel sections. The structure has a slope of 1:10 for easy entry and exit. The Ramps are fastened in the concrete using Anchor bolts.

This configuration has a single set of Bay which is 4 m long. Such a configuration is suitable for loose dirt. The trucks complete one full tyre rotation within the wheel wash system. The system is suitable for washing up to 30 trucks per hour in such Tyre wash configuration.8kl tank is preferred for heavier dirt like Iron Ore, Limestone etc, and truck traffic is less than 30 trucks per hour.Settling tanks are basically used for collection of water. In settling tank, the slit is removed by Backhoe.

Discuss your plans with us !

Standard Features

  • High Volume Discharge system
  • System with On Delay activation
  • Control System - Timer/Relay Based
  • Above ground Pump - for easy maintenance
  • Rust protected Nozzles
  • Tire Tread Squeezing structure design
  • Hot Dip Galvanised Structure

Equipment Photos

Technical Data

Structure Width3990 mm
Inside Tire Width   900 mm
Outside Tire Width3,000 mm
Structure Length10,000 mm
Maximum Axle Load25,000 kg
Bay Dimensions 
Length4,000 mm
Width3,200 mm
Voltage415 VAC / 208 VAC
Phase3 Phase
Frequency50Hz / 60 Hz
GeneratorCan also run on Backup Generator System
Connected Load17 hp /12.7 kW
Water Supply 
Flow rate50 mm @ 2 - 3 bar0


This site uses cookies. By continuing to use this site or clicking "I Agree", you agree to the use of cookies.