Portable Tire Wash System TW610 8.4 AGC

Key Features

  • Internet Enable Connection System
  • Heavy Structural Steel Base
  • Openable Nozzle Location for Easy Maintenance
  • Hot Dip Galvanised Structure


TW610 is a Tire Wash system is installed in portable configuration. The wash bay can be mounted on any level concrete road or area. The system has water collection  system to transfer the collected water to a nearby collection tank. Steel Ramps are required for vehicle entry and exit. The structure is made up of Hot Dip galvanised steel. The zinc protection gives a long life. Entry and Exit ramps are skid proof, made with heavy galvanised steel sections. The structure has a slope of 1:10. The Ramps are fastened in the concrete using Anchor bolts.

A Collection tank has been provided to collect the water from the Tyre Wash Bay. The tank is made of steel and has a capacity of 1000 liters / 265 gallons(US). A submersible sludge pump is used to pump the water from this tank to the above ground tank. This configuration has a single set of Bay which is 4 m long. Such a configuration is suitable for loose dirt. The trucks complete one full tyre rotation within the wheel wash system. We have seen our customers washing up to 30 trucks per hour in such Tyre wash configuration.8kl tank is preferred for heavier dirt like Iron Ore, Limestone etc, and truck traffic is less than 30 trucks per hour. Dirt trap system is basically a Sludge- Oil Separator, tank with Scraper Conveyor which removes the dirt settled on the bottom and a oil skimmer to remove oil, hydraulic fluids from the water.

Discuss your plans with us !

Standard Features

  • High Volume Discharge system
  • Tire Tread Squeezing structure design
  • Hot Dip Galvanised Structure
  • Rust protected Nozzles
  • Above ground Pump - for easy maintenance
  • Control System - Timer/Relay Based
  • System with On Delay activation

Optional Addons

  • Splash Guard

Equipment Photos

Technical Data

Structure Width3990 mm
Inside Tire Width   900 mm
Outside Tire Width3,000 mm
Structure Length10,000 mm
Maximum Axle Load25,000 kg
Bay Dimensions 
Length4,000 mm
Width3,200 mm
Voltage415 VAC / 208 VAC
Phase3 Phase
Frequency50Hz / 60 Hz
GeneratorCan also run on Backup Generator System
Connected Load17 hp /12.7 kW
Water Supply 
Flow rate50 mm @ 2 - 3 bar


This site uses cookies. By continuing to use this site or clicking "I Agree", you agree to the use of cookies.